The secret to the end of painting and reclassifying your pool ...
Other epoxies, paints, and coatings,
dry from the bottom up, causing hydration (water, air, and metal out), pushing out
new coating has been applied, causing pinholes to appear, and the new coating is delaminating, flaking, peeling or blistering. That's why other products FAIL! Other coatings require
ArmorGuard coatings dry top-to-bottom, eliminating pinholes and adhering to the surface permanently with a chemical bond strength of 14,000 psi,
unsurpassed by other coatings. ArmorGuard coatings are ready to fill with water after just 36-48 hours.
How our system works ...
The ArmorGuard waterproofing system is applied in 3 simple steps with 3 advanced products.
Step one - PROTOSEAL
Muriatic acid and TSP have become a product of the past when you use ArmorGuard concrete cleaner. Muriatic acid creates a salt that causes many other coatings to fail because the salts were not properly removed.
ArmorGuard Cleaner is a revolutionary cleaner that removes oils, greases, waxes, and etches concrete without VOC.
(Calcareous Calcium) to good calcium silicate, which is extremely hard and will bond with concrete permanently. This also acts as a penetrating sealer that will stop contamination. from the surfacing, like hydrostatic pressure, blisters, and other problems. Ask any chemist or engineer and they will tell you that this is a form of crystallization that helps
prevent steam transmission.
Step two - CLEANER
The proposal was designed to solve a problem ... and that problem is ... moisture! Moisture is the biggest problem facing coating companies today. A proposal when applied Concrete and masonry products enter the pores and expand to seal in moisture, allowing the faster application of coatings. And, when applied to freshly poured concrete, much faster cure times. They are the results.
Reductions of more than 50 to 70 percent in cure times have been observed. Unlike other crystalline sealants on the market, Protoseal will not produce crystals or force coatings to
delaminate as others do. The proposal is not a latex-based paint sealer or Portland-based cement. The proposal is an amorphous colloidal silicate hybrid and forms a semi-flexible substance
that binds deep within the cement matrix.
The proposal never dries or hardens completely, never washes, and is permanent. The proposal features the smallest particle size in the industry, allowing for much deeper penetration,
only 4 to 5 nanometers, where standard sealers can only reach 40 to 50 nanometers. Due to this unique formulation, Protoseal can also be used to force contaminants
concrete that would otherwise be trapped, only to rise and cause delamination. Protoseal has proven to be very effective. The proposal represents the most technologically advanced coating preparation in today's industry. Protoseal is completely harmless and ecological. Protoseal has an infinite lifespan.
Step three -
An application of a layer of ArmorGuard Pool Coating.
Cracks, leaks, and holes
Cracks, leaks, and holes are not a problem that we develop a polymer reinforced trowel mix that is 10 times stronger than concrete and will permanently seal those problem areas. We also have an underwater crack repair palette mix that will work fully cure underwater; you don't have to drain your pool.
More info Click Here
No comments:
Post a Comment